hey guys, i was asked by my division manager to check out an MXM453N, when i power up the MFP, the green L.E.D. lights up.No display,no fans,any ideas what can cause this?thanks in advance.
-
-
Re: Dead MXM453N
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com
-
Re: Dead MXM453N
Check for a bad memory chip on the MFP board; the 512mb or 1gb chip. I have seen this a few times. At power up the machine will be completely quite. After a minutes or so the fans will kick on.
Failing to plan is planning to fail!!!Comment
-
Re: Dead MXM453N
Hi
you did check the fuses?
Comment
-
Re: Dead MXM453N
Recently had the same thing in a 363 with a data security kit. Turns out the PRGM2 chip was corroded and wouldn't allow it to boot... They had to buy a whole new DSK. The cost of putting that machine in the pool is slowly catching up to them...Cthulhu for president! Why settle for the lesser evil?Comment
-
Re: Dead MXM453N
I have a similar problem on a mx453n. No image on the screen. ok touchscreen operation. Copy and print ok. I tried MFP but with the client memories ,without success. I expect the LVDS.Comment
-
Re: Dead MXM453N
hello
replacement card LVDS solved my problem. Perhaps this can help someoneComment
Comment