sharp al - 2030

[waynemohan]

i have an error on my sharp printer al-2030 , the error is h2 any one has the service manual or the error codes list

[just a tech]

h2= a thermistor open condition in your fuser unit. need to check harness and connectors to fuser. also need to check thermistor for continuity. basically, your fuser isn't heating.. find out why and ya got it fixed..lol you'll have to reset with simultion #14..but can't remember the sequence to get into maint. mode.. your best bet is to do the basics and if ya still haven't found anything, call a qualified tech to come take a look for ya. ( that is, if you're not a tech yourself..not trying to sell ya short, but there is just some things end users shouldn't play with..lol ) hope this helps..good luck..

[just a tech]

hey wayne.. check ya hotmail account ..

[jok]

How about flashing E7

Another error message that is not in the manual. Any ideas?

[paul bristol uk]

Another error message that is not in the manual. Any ideas?

and the sub code is.....

[jok]

Subcode 02

[paul bristol uk]

Subcode 02

not one I know for this M/C on a couger it is a laser unit problem though

[jok]

Thank you!