[Error Code] mx6201n pod_1n

[omega steve]

hi guys

I have a strange fault in the mx6201 in that it throws a jam first thing in the morning, and when its cleared it seem fine until the next day where exactly the same thing happens again.
looking at jam history its shows pod_1n every time but the paper hasn't left the cassette!
tried new reg sensor and transfer belt runs freely enough.

any body else seen this?

steve

[ZOOTECH]

Re: mx6201n pod_1n

hi guys

I have a strange fault in the mx6201 in that it throws a jam first thing in the morning, and when its cleared it seem fine until the next day where exactly the same thing happens again.
looking at jam history its shows pod_1n every time but the paper hasn't left the cassette!
tried new reg sensor and transfer belt runs freely enough.

any body else seen this?

steve

Try removing a sheet or two from the drawer before your first copy/print job, it just might be a "paper" problem.

[divad2k1]

Re: mx6201n pod_1n

http://www.copytechnet.com/forums/sh..._n-warmup.html