If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Is there any way to adjust the Up/Down position of a scanned image on either an MX-4101N or an MX-4111N? I've been trying to use Sim 50-1 to make adjustments. I've gotten the lead and trail positions correct.
Is there any way to adjust the Up/Down position of a scanned image on either an MX-4101N or an MX-4111N? I've been trying to use Sim 50-1 to make adjustments. I've gotten the lead and trail positions correct.
TC 50-1 is for lead edge, which sounds like you have mastered. TC 50-12 is to center the image and 50-10 is to adjust front and rear voids. TC 50-28 will do the adjustments pretty close for all (do the Setup/print adj).
"You can't trust your eyes, if your mind is out of focus"--
Comment