Offset Punch Unit on MX-PNX6B with an MX-4101N

[CES_Imaging]

I have a customer with an MX-4101N with the MX-PNX6B option installed. The punch unit does not center vertically, it is far too high up on the page. Is there a simulation or adjustment that can be done to correct this?

[ZOOTECH]

Re: Offset Punch Unit on MX-PNX6B with an MX-4101N

I have a customer with an MX-4101N with the MX-PNX6B option installed. The punch unit does not center vertically, it is far too high up on the page. Is there a simulation or adjustment that can be done to correct this?

TC 3-10 G (punch center) --- have you thought about getting a service manual?

[CES_Imaging]

Re: Offset Punch Unit on MX-PNX6B with an MX-4101N

Thank you.

I have one but I didn't think that simulations for options were listed in it. I ran into that situation with the fax unit before.