MX-FN11

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • bartrick
    Technician

    Site Contributor
    • Sep 2011
    • 11
    #1

    [Misc] MX-FN11

    Hi All!
    Have a stapler that staples in the front, and double side positions but does not staple at the rear position and just exits the paper. Has anybody seen this problem before!

    Any help would be greatly appreciated! Thanks in advance...

    The finisher is connected to a MXM4111N if that helps any.
    Tags: None
    • ZOOTECH
      Senior member of CRS

      Site Contributor
      2,500+ Posts
      • Jul 2007
      • 3375
      #2
      Re: MX-FN11

      Originally posted by bartrick
      Hi All!
      Have a stapler that staples in the front, and double side positions but does not staple at the rear position and just exits the paper. Has anybody seen this problem before!

      Any help would be greatly appreciated! Thanks in advance...

      The finisher is connected to a MXM4111N if that helps any.
      Check if the FRJHPD sensor is working - the stapler may not sense that it's at the rear position.
      "You can't trust your eyes, if your mind is out of focus" --

        Comment

        • bartrick
          Technician

          Site Contributor
          • Sep 2011
          • 11
          #3
          Re: MX-FN11

          Thanks, I will check out that sensor!!

            Comment

            • mojorolla
              The Wolf

              2,500+ Posts
              • Jan 2010
              • 2583
              #4
              Re: MX-FN11

              Also ensure you have the proper finisher firmware for that series of machine.
              Different engines require model specific firmware when it comes to finishers.


              Failing to plan is planning to fail!!!

                Comment

                Previous template Next
                Working...