If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
When installing a mx-te10 right side tray to the mx-m354n i am getting an error code f1-95
does anyone have a fix for this.
Thanx
The manual says you are not setup correctly, you need a MX-FN23 finisher installed with this tray to make it work. Do you have the finisher installed? Hope this helps.
Dan.
Comment