Sharp MX2300N E7-01 Issue

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • engineerboy93
    Technician

    50+ Posts
    • Jul 2014
    • 91
    #1

    Sharp MX2300N E7-01 Issue

    Howdy all,
    Today I went to scan some documents and what pops up, E7-01. I looked up the error code and I am looking for some experienced opinions. What is likely going to be the cause of this trouble code? In other words, what have you had to replace to eliminate this bugger?

    Thanks,
    engb93
    Tags: None
    • ruben
      The New Guy

      1,000+ Posts
      • Oct 2012
      • 1203
      #2
      Re: Sharp MX2300N E7-01 Issue

      e7-01.png

        Comment

        • engineerboy93
          Technician

          50+ Posts
          • Jul 2014
          • 91
          #3
          Re: Sharp MX2300N E7-01 Issue

          Originally posted by ruben
          [ATTACH=CONFIG]27612[/ATTACH]
          Thank you. I have the factory service manual and have performed minor service on this machine before and major service on AR series. What I am looking for is a technicians experience in this matter. Meaning that someone who has ran into an E7-01 issue and has found what to be the most common issue. Have more people found connectors that were not seated or more fried image boards?

            Comment

            • mojorolla
              The Wolf

              2,500+ Posts
              • Jan 2010
              • 2583
              #4
              Re: Sharp MX2300N E7-01 Issue

              What have you attempted thus far...?


              Failing to plan is planning to fail!!!

                Comment

                • engineerboy93
                  Technician

                  50+ Posts
                  • Jul 2014
                  • 91
                  #5
                  Re: Sharp MX2300N E7-01 Issue

                  Originally posted by mojorolla
                  What have you attempted thus far...?


                  Well when I got the machine, for free..., I opened up the back and checked everything out. All looked fine, but it is possible I may have overlooked something. I will open it up again to check for the 3rd time lol. I would hate to think the MFP is bad... I cannot find one and I'm sure they are too expensive. I'm happy for as long as it prints, when it doesn't print anymore I'm just going to throw it out. I have learned to accept that if it has electronic boards throw it out

                  I just wanted some opinions before I go open up this machine and fiddle faddle with it. Temperamental stuff I'm telling you

                    Comment

                    • engineerboy93
                      Technician

                      50+ Posts
                      • Jul 2014
                      • 91
                      #6
                      Re: Sharp MX2300N E7-01 Issue

                      Originally posted by mojorolla
                      What have you attempted thus far...?


                      Opened up the back, everything looked fine. I blew out the dust off of the connectors using an air duster. Now the machine will not start up. Just three green led's keep blinking on the backside of the MFP.

                        Comment

                        Previous template Next
                        Working...