Hi
i have an mx6201 with an fn4 finisher, it will staple fine at front side on single staples but when on normal or rear staple it goes into f1-10.
the machine stacks the paper at the tray ready for a staple and the stapler goes to its rear of the finisher position but it still thinks its seized ??
booklets work fine on lower staplers.
latest firmware for both mc and finisher.
i suspect either the ribbon cable or the finisher pwb.
any ideas plse peeps ?
kind regards
raider
i have an mx6201 with an fn4 finisher, it will staple fine at front side on single staples but when on normal or rear staple it goes into f1-10.
the machine stacks the paper at the tray ready for a staple and the stapler goes to its rear of the finisher position but it still thinks its seized ??
booklets work fine on lower staplers.
latest firmware for both mc and finisher.
i suspect either the ribbon cable or the finisher pwb.
any ideas plse peeps ?
kind regards
raider
Comment