e-Studio 20 Printer Kit GA-1031/NIC GF-1110

[Guest]

My e-Studio 20 has died, and a new (pre-loved) one has taken it's place. I'm wanting to transplant the printer kit and network card from the old machine to the new machine, since it doesn't have these options installed, and whilst I believe that my network will recognise the mac address of the newly installed (existing) card(s), I'm guessing that the machine itself will need some tweeking.

After reading these pages for a few days, it seems that I somehow enter service mode? and input some data to tell machine that it has some new components.

Is there anyone out ther who is willing/able to point me in the right direction? Passwords (sysadm?), 8-xxx codes? service information, manuals, etc
regards, and thanks in advance.

[atudorica]

your network option will work only on eStudio 16 20 25 160 200 250
you dont need to change any codes
machine will print network settings after you install the boards
you may change them from control panel
program
initial setup
network
complete

[terry081253]

your network option will work only on eStudio 16 20 25 160 200 250
you dont need to change any codes
machine will print network settings after you install the boards
you may change them from control panel
program
initial setup
network
complete

Many thanks for your advice Mr Atudorica - and for the benefit of everyone else, I followed the instructions provided, and the new machine is now full steam ahead.