ES 282 don't go ready!!!

[minhkhanh]

ES 282 don't go ready when turn on, it stoped at photocopy image screen.
I could not enter 08 or 05 and 1 3 * mode.

Help me please !!!!!!!!!!!

[ivovb]

1. Check fuser unit wiring for pressed wiring.
2. Re-flash firmware.
3. Re-set/change memory.
4. Change HDD according to SH.
5. Change Sys board according to SH.

BR

[minhkhanh]

1. Check fuser unit wiring for pressed wiring.
2. Re-flash firmware.
3. Re-set/change memory.
4. Change HDD according to SH.
5. Change Sys board according to SH.

BR

So, must I do all there think or do one of there exactly?
Thanks

[tsbservice]

I will try to narrow down the problem.
1.New HDD.
2.Firmware.

[minhkhanh]

I will try to narrow down the problem.
1.New HDD.
2.Firmware.

Thanks,
I'm going to try

My firmware is es 232 V330. Is that correct ?

[tsbservice]

Yes.

[minhkhanh]

Yes.

please tell me the way to up firmware step by step?

and what problem take note at there progess?

[minhkhanh]

Hi every body!
I tried to plug flash USB firmware in and turn on 4 9 , it take no action.
I tried to replace the HDD and make sure it was ok.

Any one help me!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!!!!!!!!!!!!!!!!!!

[decimal]

1. Check fuser unit wiring for pressed wiring.
2. Re-flash firmware.
3. Re-set/change memory.
4. Change HDD according to SH.
5. Change Sys board according to SH.

BR

I think you should replace SYS board if you can't re-flash firmware with USB .Do you have jig ?

[minhkhanh]

I think you should replace SYS board if you can't re-flash firmware with USB .Do you have jig ?

no, I do not have
How could I get it, and how can I reflash