dp6570 network controller

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • nmain
    #1

    dp6570 network controller

    I'm trying to set up a dp6570 on a network. I just bought a network card that goes into the left side into what kinda looks like a PCI slot on the machine. I went to the setup screen on the machine and assigned it an IP address, and then tried to add a printer using that same IP on my computer. This didn't work. I got a router and connected both my Laptop and the dp6570 to it and this did not work either. The router is only showing my laptop as the only device connected to it.

    Also on the card itself there's two lights where the ethernet cable plugs in. Only the green light comes on, the other light (which I'm assuming is yellow) is neither on nor blinking.

    I'm a PC tech and I work on networks a lot but cannot for the life of me figure out why this isn't working. I can only think it's a bad card.

    So:

    a)Can anyone help me configure this or

    b) Does anyone know where I can find another network controller I don't even mind an SC-2 controller.

    Thanks
    Nate
    Tags: controller, dp6570, email address, lef, life, network, network controller, rolle, sc-2 controller
    • Toshiba911
      Technician
      • Apr 2009
      • 24
      #2
      The first, you must set up the IP address for the copier manual suitable with your network, where you located the machine.

      After that, in computer you must set up 02 software: Map and P2P it will help to find the printer in the network

      After that,you can setup printer like the other

        Comment

        • nmain
          #3
          Originally posted by Toshiba911
          The first, you must set up the IP address for the copier manual suitable with your network, where you located the machine.

          After that, in computer you must set up 02 software: Map and P2P it will help to find the printer in the network

          After that,you can setup printer like the other
          Thanks for you response Toshiba911.
          I had done the first part (assigning an IP to the machine on the machine's menu) But, I don't quite understand what you meant by "set up 02 software" Is this a special software for the machine? I didn't get any kind of software with this machine.
          Thanks again,
          Nathan

            Comment

            • Toshiba911
              Technician
              • Apr 2009
              • 24
              #4
              That software I will send to you.
              Give me your email address.

                Comment

                • aalex_bom
                  Trusted Tech
                  • Jan 2008
                  • 214
                  #5
                  map and P2p

                  you can download at site

                  Index of /downloads/Drivers/DP-4580-6570-8070/Utility

                  good luck

                    Comment

                    • nmain
                      #6
                      DP 6570

                      IT WORKED LIKE A CHARM!!!

                      Thank you so much guys!!!

                      Nate.

                        Comment

                        Previous template Next
                        Working...