How do i reset the technician led blinking on display ???
toshiba bd1510
Collapse
X
-
CJ@CTS
08-79?
Hold 0 and 8 buttons down while turning it on. 7,9, start, clear/stop, interrupt. Hope you replaced the developer. CJ -
CJ@CTS
CJ again
Previous reply was to reset pm counter. If unit is not working, hold down clear/stop and 8 to read the code relating to the problem. Post the code if needed. C7 is fuser problem. Usually lamp or thermistor. There's also a reset for this code but am reluctant to provide it as much more damage can be done if it's done without the problem being corrected first. U a tech? CJComment
-
sunny
Hi CJ
I hold 0 and 8 while turning on
I get ad
I pres 7.9 then grren button start , display shows 066 some later 412
Then I press clear/stop ad back again.
switched off/on but technician/PM sign stays.
pressing clear/stop and 8 at startup no fault code in display.
do you have some more info ?
thanks sunnyComment
-
sunny
BD1550
Hi,
I tried this but it did not work.
What do you meen by interupt i suggetst it is the yellow button C/^ key.
thanks sunnyComment
-
CJ@CTS
-
0+8 power on 79 enter set to 0 and hit interrupt recycle power on the machine This will reset the PM counter. Then take the 1550 and throw it out the window. This is by far one of the biggest dogs Toshiba ever put out.sigpic No! we never do that with the copier.Comment
Comment