Toshiba E35 Missfeed paper after Print Correctly

[Guest]

Hello
i Need some help with my toshiba estudio35 as soon i turn it on i can print 1 page correctly but after that i get a misffed jam paper error this on the display is indicate at the drum/developer location however i removed both and checked replaced them and still get the same error so i need to switch off and on the printer to get rid of the error but still let me print only 1 page
can anybody please hel me to resolve this problem
thank you

[ivovb]

Could You please check error code. While there is an indication for paper jam press Clear and 8 together and the code is displayed. Anyway it sounds like exit sensor.

BR

[emujo]

I agree, the fuser exit actuator is problematic on these (and 450/452). The flag bulges at the tip and hangs up. In addition, the sensors location right over the fuser exposes it to excessive heat. You can take a sensor from any of the trays, and switch them around to trouble-shoot. EMujo

[diodeled]

Thank you for the help error number is 177731
thank you again

[emujo]

I believe that is a copy count. Error code can be obtained by holding down the "C" and "8" keys while the machine is in a jammed condtion. Should display EXXX, FXXX, or CXXXX. EMujo

[diodeled]

yes sorry you right the actually error is E55 thank you

[emujo]

E55 is paper remaining on transport path after CRUN is off. I usually solve many of these "ghost" jams by puling the transport path apart and cleaning all the sensors. The flags are loacated in the middle of the path, but the senors are at the rear. Over time they get dirty and cause these types of jams. My guess is the sync sensor is hanging up, or mis reading. Emujo