Toshiba E-Studio 720 Finisher CB-30 Error

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Wild Bill
    Senior Tech

    500+ Posts
    • Jul 2005
    • 774
    #1

    Toshiba E-Studio 720 Finisher CB-30 Error

    Izzy
    Tags: 720, cb30, copier error code, copier error code list, copyi, error, estudio, finisher, toshiba, tray2
    • Mr Spock
      Vulcan Inventor of Death

      1,000+ Posts
      • Aug 2006
      • 2064
      #2
      I had this when one of the wires was pinched. I think it was the one going to the lower home sensor. The "manual" and tech support told me to replace it but I just soldered it back together and never went back. I was under one of the tywraps near a 90 degree bend in the wiring harness.
      And Star Trek was just a tv show...yeah right!

        Comment

        • emujo
          Field Supervisor

          2,500+ Posts
          • Jun 2009
          • 3009
          #3
          Some techs pull the finisher guide rail from the machine when working on it and do not re-install it (I'm guilty also). When the customer gets a jam, they pull the finisher to far from the main body and start yanking on the interface cord. Over time the wires start to break. If this is your situation, replace the interface cable. Tray motors and the wiring harness are good candidates for this error code too. You should be able to hear tray motor problems as the tray moves up and down. Emujo
          If you don't see your question answered in the forum, please don't think it's OK to PM me for a personal reply...I do not give out firmware and/or manuals.

            Comment

            Previous template Next
            Working...