Can this machine staple letter r paper? It staples letter paper fine and ledger. When i try letter r or legal it runs the pages and stacks them, then just pushes them out. It codes EAE0 after it pushes them out. The manual says replace the sorter board.
MJ1101 on a 3510C LetterR Staple
Collapse
X
-
Check the firmware version of the finisher (08-909 or 908) If it is below 22 then I would update it.
Check the following
1 the connectors on the finisher pwb
2 the cable between finisher and main body
3 the cnv pwb (small daughter card on the lgc pwb)
4 the finisher input sensor. this is the first sensor that the paper hits when entering the finisher. I have had this stick and and cause the eae0 errors. Also check the sensors in the bridge unit. they may be flaky and not give the finisher the proper timing cycles for the job.
5 check the stapler movement if the stapler does not move it can also cause the timeout error.
Other wise it should staple letter r and legal as easily as letter and ledger.And Star Trek was just a tv show...yeah right!
Comment