how to install toshiba estdio 35

??????????????????

[Nazakat]

Butt Sab,

You have only GL-1010 Drivers or GL-1010 Dss also installed? If GL-1010 is installed you can find Network card in it.Or even if you have only Printer Card installed,you will find both port Paralell and Ether net port.
1st Check you have any of the Device i mentioned above.







Toshiba in Bad Condition in Paksitan but...........Main Hoon Na

ip address setting

print a config page (if the copier has not already done so) check the ip address already assingned. Make sure your laptop is within that range. Web browse it. Log in as administrator. Pw is normally 12345. reset the ip address to what you require, inc subnet. Save & reboot copier. if you dont understand this then you really need to go on some sort of basic pc link course.

[nasrullahbutt]

In order to print to an Estudio 35 you must have a network card to interface to the controller. Set up a standard TCP/IP port to print to and assign the copier an IP address. Sounds like you do not have all the hardware you need.

thanks to reply dear but can u tell me how i assighn IP address in Copier

[Boogotshot]

In order to print to an Estudio 35 you must have a network card to interface to the controller. Set up a standard TCP/IP port to print to and assign the copier an IP address. Sounds like you do not have all the hardware you need.

[nasrullahbutt]

hi all
i have estdio 35 with bulit in computer. and i have GL1010 Driver also but i dont know how to configer as a printer
thier is no LPT but in computer thier is lan card but in copier thier in nothing how i contact as a printer