serious problem several e-studio 520 series

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • mhmsaqer
    replied
    Do you mean that the machine does not reach ready state ?
    in addition to above try to check the Drum thermistor

    BR,
    Mohammed

    Leave a comment:


  • jamesyboy
    replied
    check fuser male /female connector for damage,format hdd,check harness running under fusing unit to lwr rear connector from ih board

    Leave a comment:


  • marcelo_canon
    replied
    fuser was replaced completely, the heater control board. What he decided was the replacement logic board. I wonder whether it was possible to repair plate to be logic board.

    Leave a comment:


  • Mr Spock
    replied
    I think it is the fuser and I would check the tension screws are all the way down and the shipping screws are removed. Otherwise I would check the thermistors.

    Leave a comment:


  • ivovb
    replied
    Originally posted by marcelo_canon
    There's not the machine code. And not enter into standbay.
    Did You mean that machine can not go to ready status - READY on the display. And showing warming up...?

    Leave a comment:


  • marcelo_canon
    replied
    There's not the machine code. And not enter into standbay.

    did upgrade with jig. I copied the values of the modes of service 05 and 08 a machine that works.

    Leave a comment:


  • ivovb
    replied
    I can not understand your English - may be it is me.

    Is there any kind of code - call for service (C..., F....), paper jam (E....)?

    Leave a comment:


  • serious problem several e-studio 520 series

    I have many machines and studio-520,600,720,850 with the following problem:

    The machines are having problems with the merger. Are stops in five minutes so ready copies and prints but not fix.

    Sorry for the english but I'm using a translator. I'm from Brazil. I appreciate the help of you's.
Working...