Toshiba E-studio 452, finisher not recognized

[mntech]

Hello,
I've added a bridge unit and a finisher to a 452 that has not had a finisher attached before, the machine is not recognizing the finisher(i've tried 2 different known working finishers, and have verified that the bridge unit is working correctly.

Is there an 08 setting that tells that machine to allow for a finisher, i've never had to make any changes before, just plug it in and good to go.

The machine did not have a finisher before, because i had to punch out the cover where the finisher attaches.

Let me know what you guys think.

Thanks,
-MN Tech

[Go Nad]

Did you install the ipc board?

[mntech]

I wasn't aware that they needed an extra board to enable the finishers, i figured if it had the connector, it was already installed.

Thanks for the help!

[Go Nad]

Did you find the board?

[mntech]

Yea, the machine didn't have the board, so i was able to pull one out of a parts machines.

Thanks for the help.