If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
yea look it up in the service manual
sounds like a finisher error but don't have the manual open instead i am openning a much more important tool
MY BEER TGIF
Color auto-toner sensor abnormality: The connection of the color auto-toner sensor cannot be detected at the initialization, or the output value of color auto-toner sensor when the revolver starts rotating for initialization is out of a specified range.
try cleaning the patch sensor (air only) and see if that works, if not replace the patch then the sensor.
ok. I have taken it apart cleaned sensor and patch. cannot acess 05 mode. 08 will come up but not 05 for calibration. I have all the manuals thanks, lol. thinking i might need some firmware here. anyone have it available?
Comment