I need to replace the sys board in a 3511 is there a procedure that needs to be done in 08 mode when the physical swap is done. All I remember is 08-995.
-
-
Re: Sys Board Procedure 3511
This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals ~ The Internet's largest selection of manuals ~ Instant Downloads
Paul@justmanuals.com -
Re: Sys Board Procedure 3511
you don't really have to do anything unless your going to switch out the serial # i would recommend a firmware update thoeComment
-
Re: Sys Board Procedure 3511
How do I handle the PM and other counters being off now? 08-999 didn't look like it did anything except transfer the total count to the 999 bank. Do I do the nvram to sram transfer or will these update themselves after some use.Comment
-
Re: Sys Board Procedure 3511
i would recommend u just do
08-250 sets the PM count
08-251 is the current value of the PM- Check the serial number after performing 08 Code 995. If the number is different from the num-ber on the label attached on the rear cover of the machine, re-input the correct number with 08Code 995.
if your going to do the nvram change, you should make sure you have the firmware... or you will probably get problems in the future.
i never really do it so you should be good
Comment
- Check the serial number after performing 08 Code 995. If the number is different from the num-ber on the label attached on the rear cover of the machine, re-input the correct number with 08Code 995.
Comment