If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
After replaced new developer material, u need to perform 05-200 for auto toner adjustment.
According to the manual, before replacing the developer, u must perform 05-280 without the toner. After this, replace developer, replace drum, adjust the developer gap (if necessarily) and then perform 05-200,also without the toner bottle. If the copy comes out ok, reset the pm counter with 08-252 to 0. Good luck.
Comment