e studio 232 not stapling correctly

[User Name]

I wanted to upload a pic to show how it's not stapling correctly but copytechnet isn't letting me for some reason. :/


Basically, it's not folding the staples down all the way. Like when it folds them over on the reverse of the pages stapled, the staples aren't folded completely down and stick up from the paper. I hope that makes sense. I'm not sure if there are any adjustments that I can make in the service mode that can correct this but it's probably more of a mechanical issue. Idk. Any advice is appreciated. Thanks!

[sdrawkcab]

Re: e studio 232 not stapling correctly

Do you seriously think this can be fixed in service mode?

It's a mechanical problem.

[User Name]

Re: e studio 232 not stapling correctly

Not really, but I can hope can't I?

I figured it was mechanical and I was hoping someone may have run into this issue before and would have some advice because I can't figure out exactly why it's not working. Everything looks like it's working right but it's just not stapling completely.

[Mad_Coachman]

Re: e studio 232 not stapling correctly

Not really, but I can hope can't I?

I figured it was mechanical and I was hoping someone may have run into this issue before and would have some advice because I can't figure out exactly why it's not working. Everything looks like it's working right but it's just not stapling completely.

There are no adjustments. Replace the stapler.

[michaelc]

Re: e studio 232 not stapling correctly

What is the model of the finisher? It does seem like a an issue with the staple unit rather than a code you can change on the machine. How may pages are you stapling ?

[User Name]

Re: e studio 232 not stapling correctly

What is the model of the finisher? It does seem like a an issue with the staple unit rather than a code you can change on the machine. How may pages are you stapling ?

Yeah, I figured it was a problem with the stapler. It doesn't matter now. This particular customer decided to purchase a new copier from one of our competitors so I didn't bother going any further with it. Thanks for the response though!