[Jamming] Toshiba E-181 Adding toner Symbole

[mdsantt]

e-181 shows adding toner symbole even after replacing the genuine toners, the problum presist after reset the machine switch ON with 13* kets. When again i use 13* the add toner symbole not displayed. but after powering OFF and ON the machine again the add toner symbole comes. how to rectify the problem.

ever replacing mainboard ,do not be lost.

input 0-8 and 971 active the value for 3, the toner symbol will disabled , do not be lost .

[mdsantt]

Re: Toshiba E-181 Adding toner Symbole

i have the same problem a few days ago..

first, open front door, get toner cartridge out and then check toner chip reader. use flashlight to see springs of reader.
if everything is ok, when cartridge is at outside, turn off machine, apply 05 - 200 and then 05 - 201 (developer initialize). read first 05 mode on servicehandbook to set values to their initial values! after this steps turn on machine and get toner cartridge in..

check toner codes T-1810E or T-1810D (E for europe machine which has serial number MJD...) (D for asiasuudiarabia machine which has serial number ASU...)