Toshiba e-studio 310C print controller fiery crash

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • mandd
    • Jun 2025

    #1

    Toshiba e-studio 310C print controller fiery crash

    I have a problem, power reset while Fiery was doing something.
    Fiery Boots, but then I get "Please Wait", firmware appars to be nuked
    Current firmware/bios X3e+ Rev E
    I can still connect to it with Colour Wise Pro,
    however it ignores all print requests.
    fiery controller GA-1120
    I took the hard drive out, perhaps there is an image out there that I can write on it, and by doing that, magically fixing my Fiery?
    There is also a recovery CD from EFI, I think...
    any advice?
    Thank you!
  • iMind
    Vacuum Cleaning Expert

    1,000+ Posts
    • Mar 2008
    • 1116

    #2
    Originally posted by mandd
    I have a problem, power reset while Fiery was doing something.
    Fiery Boots, but then I get "Please Wait", firmware appars to be nuked
    Current firmware/bios X3e+ Rev E
    I can still connect to it with Colour Wise Pro,
    however it ignores all print requests.
    fiery controller GA-1120
    I took the hard drive out, perhaps there is an image out there that I can write on it, and by doing that, magically fixing my Fiery?
    There is also a recovery CD from EFI, I think...
    any advice?
    Thank you!
    Hi, on ricohs, when the fiery displays "Please wait", you´ll have to install the fiery system, this system CD is like windows boots form CD and take more or less 40 minutes to install. sounds like bad news.
    sigpicWe can all Win, but at the end we all loose. Save the greyhound

    Comment

    • mandd

      #3
      where can I find that CD?
      I looked everywhere..

      Comment

      Working...