Pulling DV ES 281C

[vincent64]

Got a older 281c, yes I know, but cust wont part with it yet, its been pulling developer on us, getting the diag. stripe pattern on the mag roller, cleaned up the main charge yesterday, anything else I should think of on this beast, before we put new DV in it again, and dv was found in waste toner tank also.
Thanks ya'll

[canonbundy]

Re: Pulling DV ES 281C

Got a older 281c, yes I know, but cust wont part with it yet, its been pulling developer on us, getting the diag. stripe pattern on the mag roller, cleaned up the main charge yesterday, anything else I should think of on this beast, before we put new DV in it again, and dv was found in waste toner tank also.
Thanks ya'll

Yep, that's what happens when the Grid is burnt & the Dev builds up in the Main Charge Blocks (shorting Charge Wire) & a worn Drum & Blade.

Replace & clean the above, then > 6+Start > 2 & zero the parts replaced - perform calibration in 05 Mode.