Toshiba e-studio 256se scanner and radf update failure

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • drolfe@webmail.co.za
    Technician

    50+ Posts
    • Sep 2012
    • 69

    #16
    Re: Toshiba e-studio 256se scanner and radf update failure

    Originally posted by drolfe@webmail.co.za
    the red dot is 3ccd firmware, can you make a print from the computer cause if you have updated the incorrect firmware it will make a print but wont make a copy. if so the only way to repair it is with the jig or contact the toshiba distributor and send them the scanner board and they will put the correct firmware on for you
    if you have the T169SLGWW.02 firmware then you have the 4CCD which is wrong

    Comment

    • didi2005
      Trusted Tech

      250+ Posts
      • May 2011
      • 401

      #17
      Re: Toshiba e-studio 256se scanner and radf update failure

      Recently I've just updated firmware for e356se yellow dot 4ccd type due to MFP not able to power OFF...Everything run out smoothly except the RADF update failed with error R13... Luckily it doesn't affect the MFP and the RADF is working...No idea what is going wrong...

      RADF_R13.jpg

      Comment

      • drolfe@webmail.co.za
        Technician

        50+ Posts
        • Sep 2012
        • 69

        #18
        Re: Toshiba e-studio 256se scanner and radf update failure

        Originally posted by didi2005
        Recently I've just updated firmware for e356se yellow dot 4ccd type due to MFP not able to power OFF...Everything run out smoothly except the RADF update failed with error R13... Luckily it doesn't affect the MFP and the RADF is working...No idea what is going wrong...

        [ATTACH=CONFIG]29830[/ATTACH]
        I have attached the scrrenshot of the files for the firmware update if that helps any
        Attached Files

        Comment

        • jobert
          Technician
          • Jan 2011
          • 49

          #19
          Re: Toshiba e-studio 256se scanner and radf update failure

          I have the correct file. Maybe someone did, because as I posted before I saw the firmware installed was T169SLGWW.02 before I did my updating. I have .01N file. Please read the entire posts before posting. But thanks to all for the support. I have the download jig K-PWA-DLM-320 which I will try on later.

          Sent from my GT-I9300 using Tapatalk

          Comment

          • Thomas007
            Technician
            • Jul 2013
            • 49

            #20
            Re: Toshiba e-studio 256se scanner and radf update failure

            this is why there is error to update RADF.

            RADF UPDATE ERROR.pdf

            Comment

            Working...