If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi guys. I'm having the following error message on a xerox 3220 : LSU Hsync error - cycle power off. I changed the formatter and lsu; i put in a 3210 formatter and lsu. THe problem now is this : it gives the same message and the page comes out blank. The mfc came with the following problem : it printed one page and then gave the message i was talking about. The polygon motor is spinning, i can hear it. Do you think it can be the power supply? I can think of nothing else. Tried with other firmware, factory resets : same thing.