[Error Code] Xerox 700 077-113 fault code

[PragmaGraphix]

Hello, wondered if anyone can quickly tell me where to locate the IOT Exit Sensor in the main unit. I just purchased a Xerox 700, have it all set up and paper leaving the main unit stops as it is entering the Interface Module and says it is jammed. The fault code is Xerox 700 077-113 which is the "IOT Exit Sensor did not turn off at the specified time in non-invert mode." I'm assuming that the sensor is an actuator and possible needs to be cleaned or changed. I need to get this machine up and running ASAP. Any help is so appreciated!

[Tam]

Re: Xerox 700 077-113 fault code

Hi
Did you fix the problem? How? I'm having the same problem with the same fault code but only with 300gsm paper