WC 7845 with LX finisher

[scottybbb]

The eject pinch rolls in the LX finisher intermittently do not raise up and paper crashes into them. Tested in service mode and can make pinch rolls move up and down. Took gears in back off and did not anything broken other than an actuator that I replaced. Anybody had an issue with this finisher?

[vodo]

Re: WC 7845 with LX finisher

The eject pinch rolls in the LX finisher intermittently do not raise up and paper crashes into them. Tested in service mode and can make pinch rolls move up and down. Took gears in back off and did not anything broken other than an actuator that I replaced. Anybody had an issue with this finisher?

Its bushing needed to replace. Previously Xerox made that by plastic. The new one, it's brass. But, to ensure it will work properly, you will have to replace its clutch too. I do believe there is a bulletin for that modification.

[Exok]

Re: WC 7845 with LX finisher

file-page1.jpgfile-page2.jpgfile-page3.jpgfile-page4.jpgfile-page5.jpgfile-page6.jpgfile-page7.jpgfile-page8.jpg

[scottybbb]

Re: WC 7845 with LX finisher

Thanks I will order those parts.