Hi friends
i have a machine xerox wc 5645 with built in controller ends on 5 dots when powered on and sometimes it gets ready.
When it ready and it goes in to power save mode or sleep mode, it does not wake up when pressed any button so it stays there until you plug out the power cable.
Another thing is when you try powering it down, it refuses to power down.
i observed that when it ends on 5 dots and i try reseating all cables on the SBC board, software module( nvm module), the RAM chip and the hard driver, it boots up to ready state but i checked the SBC was working fine even i went ahead replacing the memory chip and reloaded system software but nothing changed.
Could it be the software module, hard drive or power supply disturbing the machine.
i need some help please because i have done alot.
i have a machine xerox wc 5645 with built in controller ends on 5 dots when powered on and sometimes it gets ready.
When it ready and it goes in to power save mode or sleep mode, it does not wake up when pressed any button so it stays there until you plug out the power cable.
Another thing is when you try powering it down, it refuses to power down.
i observed that when it ends on 5 dots and i try reseating all cables on the SBC board, software module( nvm module), the RAM chip and the hard driver, it boots up to ready state but i checked the SBC was working fine even i went ahead replacing the memory chip and reloaded system software but nothing changed.
Could it be the software module, hard drive or power supply disturbing the machine.
i need some help please because i have done alot.
Comment