Xerox Workcentre WC-4250 Idles during print job

[Arkynsaw]

Ran various sets , 5 copies off glass , 5 pages through ADF , 10 pages with ADF to 2 sided , 5 2 sided to 2 sided - Intermittently it will stop printing and start to idle for about 30 seconds to a minute , then start printing again , scanning had finished normally . seems to have plenty of toner , machine says 70% remains . Toner doors seem to be opening fine , no mess on top of drum unit . Print quality is a little light but OK . Drum has 30% life left . Using OEM supplies . About 320 K on machine , has a new transfer roller and new fuser , both have been reset . Anyone seen this ? Hoping for an answer , thanks in advance , Ark .

[Flash]

Re: Xerox Workcentre WC-4250 Idles during print job

Do a memory clear in service mode. Make sure you clone the network settings first. It will delete all the network settings and address book. You will have to reset date and time and set fax up.