Xerox EX80 Print server

[ad41061]

Hi My EX80 printer server died and I replaced the motherboard for the same type 2nd hand, but now the printer server won't start (something about encryption on the board) I think I have all the firey disks ,( see image) I also have the lincence key so will I be able to reinstall the printer server using this disk or do I need to use the System Softwear 2,3 seem to be missing System Softwear 1, is it possibale to get this disk somewhere?

Thank you for you help

ad



20240513_193903.jpg
20240510_203226.jpg

[adriansto]

There are 4 DVDs for EX80 serial R9A. With the 3 dvds shown in the pictures you can install the system software. Fourth dvd contain Fiery drivers and utilities.

[xcopytech]

You can not finish installation without dvd 4.
Did you get motherboard from same fiery, ex80

[ad41061]

Thank you from replys, No the motherboard was bought 2nd hand its just the same type of board I dont think its from a fiery.
Ye I think I need the DVD system Softwear 1 in order to reinstall the print server is that correct?

[xcopytech]

I do not think you will be able to use motherboard without one time usb dongle which you get when buy new motherboard from xerox or efi

[henrycool]

Is it POssible to install system software with out the dongle or with some other dongle from a different v80 server ?

[xcopytech]

If you did not replace motherboard then you can install fiery software without dongle