Xerox D95,4110 Developer Installation

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • bryant28282000
    Trusted Tech
    • Jul 2012
    • 145
    #1

    Xerox D95,4110 Developer Installation

    Hello everyone, Do anyone know what the adjustments are for D95 after you install new developer? This is the only edoc I don’t have on my computer or of their is a pdf version. I am also have problems on three machines where the developer/toner is dropping on the pre transfer belt sensor Anyone know the solution?
    Tags: None
    • adriansto
      Service Manager

      Site Contributor
      VIP Subscriber
      1,000+ Posts
      • Nov 2007
      • 2369
      #2
      Originally posted by bryant28282000
      Hello everyone, Do anyone know what the adjustments are for D95 after you install new developer? This is the only edoc I don’t have on my computer or of their is a pdf version. I am also have problems on three machines where the developer/toner is dropping on the pre transfer belt sensor Anyone know the solution?
      After change dev. material go to diagnostic mode - Maxsetup - Default developer ATC sensor setup.

        Comment

        • MRJESSE
          Technician
          • Jun 2017
          • 41
          #3
          How did you fix this?

          Originally posted by bryant28282000
          Hello everyone, Do anyone know what the adjustments are for D95 after you install new developer? This is the only edoc I don’t have on my computer or of their is a pdf version. I am also have problems on three machines where the developer/toner is dropping on the pre transfer belt sensor Anyone know the solution?

            Comment

            Previous template Next
            Working...