Xerox 700 Registration

[PaulNeB]

Hello, I have a problem with the Xerox 700 that there are black lines on one edge of the paper at a distance of 3mm.
These lines extend about 2mm into the paper format. I have already changed the registration in the NVM, but the lines remain.
This happens with every job and with different paper formats.

[adriansto]

Hello, I have a problem with the Xerox 700 that there are black lines on one edge of the paper at a distance of 3mm.
These lines extend about 2mm into the paper format. I have already changed the registration in the NVM, but the lines remain.
This happens with every job and with different paper formats.

Post picture of paper sheet and indicate the paper lead edge.

[Milo Wilson]

Should probably do registration setup series. It will take a while.

[PaulNeB]

Post picture of paper sheet and indicate the paper lead edge.

Here is a stack of printed sheets. Arrow is printing direction

[adriansto]

Here is a stack of printed sheets. Arrow is printing direction

Check the components of registration assy= rollers, springs,so on, clean the CIS sensor and do registration procedures

[PaulNeB]

Check the components of registration assy= rollers, springs,so on, clean the CIS sensor and do registration procedures

Thanks, it was the register. The sensor was dirty.
Settings difficult and time consuming to adjust.