Good evening! This morning i had a problem with one DC12 ..Power Save led is green but the copier does nothing... LPVS changed but the machine still does not turn on...Any ideas would be welcomed...thanks in advance!!
-
-
When you turn on the copier and you go to power saver mode then you have a problem with AC driver PCB.a machine is only as good as your tech : source:screwtape ; the scary one -
Check fuses on power distribution pwb.
if fuses ok, then check IOT NVM pwb.Comment
-
ty very much both of you...i ll try to replace them i ll tell you the results!!Comment
-
i ve changed the IOT NVM and everything is fine now...ty very much..Comment
Comment