Need help please on xerox c60

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • amr_1_4
    Technician
    • Nov 2015
    • 17

    #1

    Need help please on xerox c60

    I have xerox c60 i printed only black and white , I got problem with magenta toner it’s wasted very quick,and I found it in waste cartridge
    I replaced magenta dev tank and magenta drum and magenta dispenser Assy and still same problem
  • amr_1_4
    Technician
    • Nov 2015
    • 17

    #2
    Any one gonna help me

    Comment

    • adriansto
      Service Manager

      Site Contributor
      VIP Subscriber
      1,000+ Posts
      • Nov 2007
      • 2387

      #3
      Originally posted by amr_1_4
      Any one gonna help me
      Some error codes?

      Comment

      • MRJESSE
        Technician

        50+ Posts
        • Jun 2017
        • 50

        #4
        Check that the developer powder is not low in the dev unit.
        Clean MOB sensor.
        Do a color and density calibration.

        Comment

        • amr_1_4
          Technician
          • Nov 2015
          • 17

          #5
          Originally posted by adriansto

          Some error codes?
          No error appears

          Comment

          • amr_1_4
            Technician
            • Nov 2015
            • 17

            #6
            Originally posted by MRJESSE
            Check that the developer powder is not low in the dev unit.
            Clean MOB sensor.
            Do a color and density calibration.
            The developer is perfect and i already did calibration
            not checked mob sensor yet but I will tomorrow

            Comment

            • jhalfhide
              Trusted Tech

              250+ Posts
              • Apr 2015
              • 454

              #7
              If you're magenta powder is ending up in the waste toner, it is likely that your developer bias HV board needs replacing

              Comment

              • amr_1_4
                Technician
                • Nov 2015
                • 17

                #8
                Originally posted by jhalfhide
                If you're magenta powder is ending up in the waste toner, it is likely that your developer bias HV board needs replacing
                Can u please send me where is located or part number of it ?

                Comment

                • jhalfhide
                  Trusted Tech

                  250+ Posts
                  • Apr 2015
                  • 454

                  #9
                  Originally posted by amr_1_4
                  Can u please send me where is located or part number of it ?
                  105E17732 Developer Bias HVPS (M-Top, Y-Bottom)

                  At the bottom rear, behind the main LVPS. Two little rectangular boards, the Magenta is the top one (Yellow is bottom).

                  Comment

                  • amr_1_4
                    Technician
                    • Nov 2015
                    • 17

                    #10
                    Originally posted by jhalfhide

                    105E17732 Developer Bias HVPS (M-Top, Y-Bottom)

                    At the bottom rear, behind the main LVPS. Two little rectangular boards, the Magenta is the top one (Yellow is bottom).
                    Thanks a lot brother I will give u feed back after I replace it

                    Comment

                    • jhalfhide
                      Trusted Tech

                      250+ Posts
                      • Apr 2015
                      • 454

                      #11
                      Originally posted by amr_1_4

                      Thanks a lot brother I will give u feed back after I replace it
                      You can swap with the yellow as a test, but then you'd lose your yellow Dev powder into the waste. It's not an expensive board so easier to just replace. Same board in pretty much all the entry graphics/press machines so can also swap

                      Comment

                      Working...