ApeosPort-VI C3371-after Initialize VNM Misaligned Printing Problem

[Vamp1437]

Hello...can anyone tell me how to solve this problem???
i have Apeosport-Vi C3371 and after i Initialized VNM...the Color printing its Misaligned but if B/W everything seems normal...even after i done Color Registration in CE mode...the problem still there...
and i found out only Magenta and Yellow Color misaligned...may i know is it after Initialized VNM all setting have run???and if really setting run how to set back???c523738b-06e2-4fa6-8260-c961eccf385f.jpg

[shinchan]

Re: ApeosPort-VI C3371-after Initialize VNM Misaligned Printing Problem

Hello...can anyone tell me how to solve this problem???
i have Apeosport-Vi C3371 and after i Initialized VNM...the Color printing its Misaligned but if B/W everything seems normal...even after i done Color Registration in CE mode...the problem still there...
and i found out only Magenta and Yellow Color misaligned...may i know is it after Initialized VNM all setting have run???and if really setting run how to set back???[ATTACH=CONFIG]60487[/ATTACH]

misalignment troubleshooting:
1. Check IBT belt, whether it can rotate smoothly. Does it have rubber on the sides? if there is, does the rubber already failing and dropping to the drum?
2. Check each OPC DRUM, whether it can rotate smoothly. Swap OPC DRUM, see whether the misalignment also move.
3. Clean MOB sensor. If after cleaned, still happens, replace MOB Sensor

[Vamp1437]

Re: ApeosPort-VI C3371-after Initialize VNM Misaligned Printing Problem

Ok...thanks for the reply...I'll try it first...