Cleaning unit need to be replace 4595 mfp

[KHAN]

Hello friends my XEROX 4595 display shows ERROR CLEANING UNIT NEED TO BE REPLACE, Please how to RESET the COUNTER of CLEANING UNIT , Please I need help STEP BY STEP , how to ENTER IN THE SERVICE MODE ,step by step ,because this my 1st time to work on any XEROX model,OR some one have SERVICE MANUAL , please send it to me, I will be grate full.
THANKS TO ALL.

[copymachine]

1. In the User Mode screen, press the [9] key and the [Stop] key at the same time.
2. The Replace Consumables screen appears.
3. The "Have you replaced the Fuser Cleaning Web?" message appears with [Yes] and [No] buttons.
4. Press the [Yes] button to reset the Current Value to "0".
   • DC135 [954-847] FuserWeb and DC131 [744-167] FuserWeb Motor ON Cumulative Time Upper Level (Cumulative time of FuserWeb Motor ON) are both reset to "0".
     NOTE:
     If the Fuser unit is inserted into the IOT unit when the Fuser Cleaning Cartridge is not installed, the system detects 10-400 FuserWeb Near End Warning or 10-910 FuserWeb End Fail. There are two ways to clear the errors.
     1. After installing the Fuser Cleaning Cartridge, reset the Replace Consumables again. If the Fuser Cleaning Cartridge in use is used again, the process used up to now is cleared. Instead of identifying Near Empty, the system suddenly detects 10-910 FuserWeb End Fail and shuts down.
     2. After installing the Fuser Cleaning Cartridge, set DC131 [744-167] FuserWeb Motor ON Cumulative Time Upper Level (Cumulative time of FuserWeb Motor ON) to "0" to clear the detection. If it is necessary to continue the cumulative time of FuserWeb Motor ON, note down the value of DC131 [744-167] on a paper etc, and then input this value into DC131 [744-167] that is being reset.
     
     
   
   

[KHAN]

Thanks Friend, so nice of you. Please if you have SERVICE MANUAL please also I need it,
GOD BLESS YOU.