My Fiery EX2000D starts up and opens CWS 4 but the Fiery bar at the top of the screen just sits there and says:
"Starting... Please wait"
With the green light on the top right blinking.
I can use the CWS to access the other servers I have running DC12s (X12s) but it won't log onto "itself", the EX2000D.
Reading through some of the documentation I now understand that I should have always started and shut down the RIP with the DC2060 off and this has certainly not always been the case, perhaps this is where the problem has originated.
Is there any quick fix to this?
Cheers,
Gustav
"Starting... Please wait"
With the green light on the top right blinking.
I can use the CWS to access the other servers I have running DC12s (X12s) but it won't log onto "itself", the EX2000D.
Reading through some of the documentation I now understand that I should have always started and shut down the RIP with the DC2060 off and this has certainly not always been the case, perhaps this is where the problem has originated.
Is there any quick fix to this?
Cheers,
Gustav