Xerox N32 maint counter.

[oldschool]

We have a the Docuprint N32 in our office and I have been servicing it for a long time. We have put maintenance kits in before but I'd like to rebuild one of the old fusers myself. I can get the rollers, sep claws, feed tires and BIAS roller from Precision Roller. All I need is the fuse used to reset the maintenance counter. I don't think it's a chip like the toner/drum cartridge has.
Is there another way to reset it?

[oldschool]

Found an old sheet with instructions that answered my question.
1. Make certain the printer is OFF.
2. Press and hold buttons 2 and 6 on the control panel while you switch ON printer main power. Continue holding until *IOT?* appears in the display (approximately 20 seconds).
3. When the control panel shows *IOT?* , release buttons 2 and 6, then press and hold buttons 0 and 5. Hold 0 and 5 until "Reset Complete Please Reboot" is displayed. This message confirms the counter has been reset.
4. Reboot the printer by powering OFF, waiting 20-30 seconds and powering ON.