Dots of death wcp 3545

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • tech9
    Trusted Tech

    100+ Posts
    • Apr 2009
    • 216
    #1

    Dots of death wcp 3545

    Hi have a 3545 that a fellow tech was having issues with now i have taken over,
    It was suffering from dots of deaths would not come up ready to copy.
    Fuser warms fans run and exposure lamp lights and finisher initialises.
    Should of been a straight case of replacing the CCM nvm pwb and then setting up machine configuration in DC105.
    But fellow tech replaced the MCU and the MCU NVM pwb.
    Now machine comes up power on failure machine is in non-customer mode.
    Now what i would like to know if both the CCM NVM PWB and the MCU NVM PWB and changed at the same time, is there anyway to recover the machine into a working state?
    Old MCU NVM PWB he no longer has which is a bummer.
    Tags: copy, customer, finisher, mode, power, sea, set, setting, tech, time
    • tech9
      Trusted Tech

      100+ Posts
      • Apr 2009
      • 216
      #2
      Basically once the MCU NVM PWB is changed it can only be reauthorised by Xerox via a special code, you have to connect your PWS obtain machines unique ID then request the code from Xerox. Basically its had it really !

        Comment

        • dokas0007
          #3
          Re: Dots of death wcp 3545

          I have the same problem with Xerox WC 40 pro. After replacing the CCM nvm pwb and then setting up machine configuration in DC105, I have fail code " Machine is in non-customer mode". I don t understand why this problem dont appears from another cases replacing the CCM nvm pwb and then setting up machine configuration in DC105 ( in another machines). How fix the problem without connect to "official Xerox men"?

            Comment

            • xcopytech
              Service Manager

              1,000+ Posts
              • Aug 2006
              • 1792
              #4
              Re: Dots of death wcp 3545

              also adjust dc 133 and then perform complete exit from diagnostic navigator

                Comment

                • dokas0007
                  #5
                  Re: Dots of death wcp 3545

                  I was setting up dc 133 in first of all . It is dont help . Another opinions?

                    Comment

                    • bojans
                      Service Manager

                      Site Contributor
                      1,000+ Posts
                      • Feb 2008
                      • 1313
                      #6
                      Re: Dots of death wcp 3545

                      Did you follow procedure described by adeyemi in this post?>http://www.copytechnet.com/forums/xe...-help-plz.html

                        Comment

                        • dokas0007
                          #7
                          Re: Dots of death wcp 3545

                          Yeyeyeyeye!!!! My machine WC 40 pro is working!!!!! Especially thanks for Bojan, he was guide in sea of posts in this forum and another sites!!!

                            Comment

                            • bojans
                              Service Manager

                              Site Contributor
                              1,000+ Posts
                              • Feb 2008
                              • 1313
                              #8
                              Re: Dots of death wcp 3545

                              You're welcome

                                Comment

                                Previous template Next
                                Working...