Hello everyone,
I'm looking for an independent Xerox tech. who can perform a firmware upgrade on my privately-owned DC2045 so that I can run carbonless forms. As per the DC2045 Administration Guide, page 1-76, I need to enable Chain Link #700 656 through Tools mode on the NVM Read/Write screen. However, on my machine this number is not available.
I presume this means I need a firmware update.
I'm looking for someone in the Boston-to-Hartford area who can advise and perform this upgrade for a reasonable cost.
Thanks in advance and if you are interested/can do it please give me an estimate of what you would charge through a private message.
I'm looking for an independent Xerox tech. who can perform a firmware upgrade on my privately-owned DC2045 so that I can run carbonless forms. As per the DC2045 Administration Guide, page 1-76, I need to enable Chain Link #700 656 through Tools mode on the NVM Read/Write screen. However, on my machine this number is not available.
I presume this means I need a firmware update.
I'm looking for someone in the Boston-to-Hartford area who can advise and perform this upgrade for a reasonable cost.
Thanks in advance and if you are interested/can do it please give me an estimate of what you would charge through a private message.