DC700 Black printing low gloss

[Ianizer]

Re: DC700 Black printing low gloss

Free Flow is DFE Specifications for Xerox 700

Ah. Thank you. Excuse my ignorance.
Must have been thinking of FreeForm.
-I

[ktxerox]

Re: DC700 Black printing low gloss

Dear Kalindd,
Please note my email last time i forget to write.

ktxerox@gmail.com

I'm jumping a bit late, but try this.
Take another "good working" dev unit from lets say other machine. Put it in your machine ( set TC bar numbers) print only ONE test print, check the gloss level. If its ok ( and from what you have said it should be) check the procon on and off values TAKE a photo to the UI, run the procon on ( check the values, take a photo). Make another print only one, check print if it is sill ok. Then run the 700 sheets, after that check gloss may be it will be lost. Go to service and photo again the values.
( ALL three or 4 pages I don't remember). Even make another procon on and off.
Then start your pc or even print those pictures and analyze them, see what has been changed from the machine . Lets say TC value was changed or Vgrig or Vbias.
PM me your email so I can send you explanation of procon on and off.

And just a shot, did you activated the fuser gloss mode?
Best!

[msoundpr]

Re: DC700 Edoc

Hi, I am looking for a DC700 edoc for use with pws.

Thanks

Dear Kalindd,
Please note my email last time i forget to write.

ktxerox@gmail.com

[ktxerox]

Re: DC700 Black printing low gloss

Send ma your email i have this one.

[msoundpr]

Re: DC700 Black printing low gloss

Thanks,

msoundpr@gmail.com

Send ma your email i have this one.