Xerox workcentre pro 133 and m123

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • WCSSTORE
    Technician

    Site Contributor
    • Dec 2011
    • 19

    #1

    Xerox workcentre pro 133 and m123

    Hello All

    Does anybody remember how to adjust the fuser temp on a wc pro 133 and m123. other than adjusting the paper weight.

    Thanks
    For the Help
  • JustManuals
    Field Supervisor

    5,000+ Posts
    • Jan 2006
    • 9838

    #2
    Re: Xerox workcentre pro 133 and m123

    This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


    Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


    Paul@justmanuals.com

    Comment

    • nilak
      Technician

      50+ Posts
      • Aug 2010
      • 72

      #3
      Re: Xerox workcentre pro 133 and m123

      Originally posted by WCSSTORE
      Hello All

      Does anybody remember how to adjust the fuser temp on a wc pro 133 and m123. other than adjusting the paper weight.

      Thanks
      For the Help
      in service mode nvm read/write
      744-006 Fuser Standby Lamp ON Temp 45 0~99 1 deg.C Nominal=175 deg.C
      744-010 Fuser Standby Lamp OFF Temp 20 0~99 1 deg.C Nominal=180 deg.C
      744-043 Fuser C1 Ready Temperature (T-READY) 35 0~70 1 deg.C Nominal=165 deg.C
      744-061 Fuser Low Run Temperature-(T42) 15 0~40 1 deg.C Nominal=15 deg.C
      744-065 Fuser OHP Run Temperature-(T43) 15 0~40 1 deg.C Nominal=15 deg.C
      744-080 Fuser SSTSctrlExceTM(t13) 30 0~99 1sec Nominal=30sec
      744-081 Fuser SSTSctrlExceAppP (M) 10 0~99 1page Nominal=10page
      744-133 Fuser WU STRT T70(ForSB2) 0 0~99 1 deg.C Nominal=80 deg.C
      744-134 Fuser Standby 2 On Temp (T71) 69 0~70 1 deg.C Nominal=199 deg.C
      744-135 Fuser Standby 2 Off Temp (T72) 50 0~70 1 deg.C Nominal=200 deg.C
      744-220 Fuser Reset FuserOverTemp 0 0~99 - 0: Reset, 1: FS1 Detected over temp, 2: FS2 Detected over temp, 3: ON time fail, 5: Cold Sagging fail (Only reset is possible in the diagnostics mode.)

      Comment

      Working...