XEROX DC12

[bmt_hr]

Hi

XEROX DC12

After I replaced fuser roll and pressure roll, the paper came out from printer in waves. What I need to adjust and where?

br

[fogra27]

Re: XEROX DC12

Fuser Nip

adj.8.1.1

[bmt_hr]

Re: XEROX DC12

OK, I will try again....

[LittleTurtle]

Re: XEROX DC12

Yes probably you need to check the Fuser Nip good luck hope things will work out.

[Tinochka]

Re: XEROX DC12

Hi

XEROX DC12

After I replaced fuser roll and pressure roll, the paper came out from printer in waves. What I need to adjust and where?

br

You replaced with new, genuine rolls?
I've seen compatible rolls with very low quality. After customer replaced with compatible rolls, there was waves. Only after replacing with original ones, the printer works fine. (ofcourse perform the fuser nip adjustments)

[bmt_hr]

Re: XEROX DC12

The rolls are genuine..... from Xerox

[Tinochka]

Re: XEROX DC12

The rolls are genuine..... from Xerox

Have you perform Fuser Nip adjustments?

[bmt_hr]

Re: XEROX DC12

After two hours of adjustment waves are resolved, but I was the problem with the lines of the oil on the print.

[bojans]

Re: XEROX DC12

Then clean/replace oil blade.

[bmt_hr]

Re: XEROX DC12

Already put complete new oil system (only oil pump is old - tested)...

[JustManuals]

Re: XEROX DC12

This Parts & Service Manual can now be purchased for $12.77 and downloaded immediately after payment from


Just Manuals, The Internet's largest selection of manuals ~ Instant Downloads


Paul@justmanuals.com

[Tinochka]

Re: XEROX DC12

Already put complete new oil system (only oil pump is old - tested)...

I've seen similar problem. The cause was web assy. You can replace web assy with used one, you need to remove everything include web material inside the web assy. Just try to make afew prints. You'll see the differens.

[bmt_hr]

Re: XEROX DC12

Thanks for help, i will try that tomorrow....

[bmt_hr]

Re: XEROX DC12

My problem is persisted, have somebody some idea? I am try to do what is in my power.
On print I have some oil tracks which i can clean with cotton cloth.

I need some idea.

I already replace, fuser, pressure roller, web cleaner, complete oil sistem (without pump), external heat rool....
Wave are solved with Fuser NIP (DC701).

Thanks for help.

br