workcentre5665 machine several cable connection
everyone,i do not know workcentre5665,machineseveral cable connection.because this machine is my first time doing. could you teach me? so, i do not know that there install wrong. machine can not post the photo to me. i installed the wrong and can tell me this. Thank you.DSC00040.JPGDSC00042.JPGDSC00043.JPGDSC00041.JPG
-
-
Re: workcentre5665 machine several cable connection
Standing behind the machine, on the left side, the white power cord from the print controller plugs in the lowest outlet just as you have shown in the photo.
The next outlet above that is for your machine power cord.
The next outlet above that is the power for the finisher to plug in.
Above that, the left plug is the data outlet for your finisher or output tray. (This machine requires you have either a finisher or output tray attached or you will get a fault code for communication error, there is a jumper available to test the machine without either hooked up)
Everything else looks correct as you have it shown in the photo.
The USB extension cord you have plugged in from the controller to the USB port on the main body right side rear is only needed if the machine will be using an external auditing device. -
Re: workcentre5665 machine several cable connection
ExokI do not quite understand your instructions.Can be described in detail.If you can, please take pictures clear than pay.Because my first do this aircraft machine.thank you.
Comment
Comment