If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a xerox document Centre 340 ST, the machine shows me that the machine not ready to copy, I am not familiar with xerox any help would be appreciated.
you have three gray button on right side of touch screen.
press the lower one and then go to faults tab to see which fault code you have.
only then you can get some help
I have a xerox document Centre 340 ST, the machine shows me that the machine not ready to copy, I am not familiar with xerox any help would be appreciated.
thanks in advance
hi if you finisher slide out open the left cover & check the fuser roll if it is hot or not if not you have to reset the machine via entering diag #11
50-20 change from 1to 0
Comment