Hi!! Some time ago i buy a DC260 and often misconfigured to me and a week ago I was installing patches .ps and after that lit but not grab port and are not connected with etherneth to "cws" I want to reinstall the software but I'm missing installation disks appreciate that someone could get thanks
-
-
Re: Fiery DC260
You must say what version of software the Fiery have and if it is builtin or external FieryLast edited by adriansto; 10-15-2013, 02:17 PM. -
Re: Fiery DC260
If you have an EX260 (External) that software is hard to come by. Your post was a little hard to understand, what is it doing exactly? Is the Fiery bar at the top of the screen Blue or RED. If so what does it say?
If you have a bustled fiery does the green LED counter stop at a particular number, or does it go to 00?
Make sure you have all the cables in the correct position. Then, on the DC260 push the "All services Button" Is the "Web applications" and "Network Scanning" lit or are they greyed out? If there lit you need to correctly configure your network settings. If they are greyed out their is a communication problem.
Best of Luck!Comment
-
Re: Fiery DC260
Thank you both, is the "X3eTY" the bar is blue buttons are disabled, the LED is on "00", I can not access the network settings, I can not connect by ethernetComment
-
Re: Fiery DC260
Make sure you have the EX260 connected to your router. The Printer may be configured to have the IP address automaticly assigned. Connecting it will do just that. Once its connected you should be able to access the "Network Settings", allowing you to configure it the way you want. I can further instruct you on how to do that.
Good Luck!Comment
-
Re: Fiery DC260
It's a bustled fiery, not the EX260Comment
-
Re: Fiery DC260
Sometimes it can take about 10 minutes or more for the Fiery to be recognized.. How long do you wait?Comment
Comment