Fuser for 7232 on 7132 ??

[Poldino1972]

Hi I've to change the fuser on my wc7132 (part code: 008R13023)

i have in my office a new fuser for a wc7232 (part code: 00813045)

The fuser seem to be the same. Is it possible to use it in the 7132 without problem?

Thanks

[folukems]

Re: Fuser for 7232 on 7132 ??

Are you a tech? If not give it to a xerox guy he will swap the heater rod for you and change position of the thermostat that's all it will work if not you will have 10xxx code

[Poldino1972]

Re: Fuser for 7232 on 7132 ??

Are you a tech? If not give it to a xerox guy he will swap the heater rod for you and change position of the thermostat that's all it will work if not you will have 10xxx code

Thanks for reply; i have ordered a new correct fuser and changed it .

Anothe question; we have notice a problem with the Printing. the paper result printed good only for an half page and the other half has very poor quality.

I have print some test (see attachment).

i have already installed all the maintenance kit unit (fuser, developer, belt, waste, toner, etc). but without resolve the problem.

Any idea?

Thanks, and sorry for my english.
Paolo

[nilak]

Re: Fuser for 7232 on 7132 ??

There are 2 latches on the IBT assembly and of them is not in position. Looking at Your TP it should be the one of the rear side. You can refer to PL6.2 item7 and to gain access You can use the left side door.

[Poldino1972]

Re: Fuser for 7232 on 7132 ??

There are 2 latches on the IBT assembly and of them is not in position. Looking at Your TP it should be the one of the rear side. You can refer to PL6.2 item7 and to gain access You can use the left side door.

Yesss, great. Thank you very much. it was the latch.